Used for
automatic slide door, automatic Gate Door, coil door , garage door, windows ,barrier etc.
Feature
【Receiver and Transmitter】Consists of a transmitter and a receiver, and the integrated amplifier can produce infrared beam.【Anti-interference】Narrow infrared beam (I or II) can avoid interruption by external light【Detection distance】Even installed at low height(20-40cm from the floor), the detecting distance can also be guaranteed(5-15meters).【self-detecting function】The beam produced by MICROCELL provides a self-detecting function for the sliding doors. Once the self-detecting beam is interrupted, the door will stop closing and reverse rapidly to the utmost width. The door will open until the detecting beam is resumed. When the door completely closes, the detecting beam becomes invalid.
Technical Specification
Working voltage:Transmitter : 3V (2PCS AAA battery 1.5V LR03) NOT INCLUDE, Receiver : 12-24V DCWorking current:Transmitter < 85µA, Receiver < 30mA (24V DC)Photocell wavelength: 940nmAngle of emission:≤±5°Receiving range:> 12mRelay contact loading capacity:1A/30VDCSize:100*40*35mm
Technical Specification
Control Rise And Fall Of The Gate
lnstalled on both sides of the barrier, wired to the barrier controller,when someone or a vehicle interrupts the beam, the controller willautomatically control the barrier to rise and fall or open
Reduce Accidental Injuries WhenCrossing the Gateway
After the installation of the opposite shot, when people pass through the gate,the gate switch is automatically controlled, which can greatly reduce theoccurrence of accidental injury.
The strongest range can reach fifteen meters
Severe weather will be reduced
Safety Instruction
1.For security, please read the user manual carefully before initial operation;2.This photocell is without any fuse,so Please make sure the power is off before installation;3.Only used this system that do not cause any danger life or property during the running failure or its security risks eliminated;4.Please guarantee the products used in effective working range
Installation instruction
4.1 Receive module J4 in above picture is the option switch for NO and NC of photocell switch.4.1.1When the short circuit cap on NO,it is normally open.4.1.2 When the short circuit cap on NC,it is normally closed.4.2 Installation4.2.1 The photocell should be installed more than 20cm above the ground (to avoid reflection), and the distance between emitterand receiver should be more than 50cm.4.2.2 End user should install the photocell receiver on the back of the direct sunlight or other strong light source(±5-) to keep photocell work well steadily.4.2.3 Avoid installing other infrared photocell emitters within the effective distance of receiver.4.2.4 If the end user need to install other photocells in one same straight line , the receivers could be installed in the two ends and the emitters could be back-to-back installed.4.2.5 Stable installation could avoid the signal of emitter and receiver skewing due to lightly vibrate and the malfunction.4.2.6 When the product is install in some place with angle , end user could adjust the PCBA to make the installation better.4.2.7 Connect the power after the inspection, when short circuit cap at NO, After the battery is installed on the LED lamp of the transmitting module, the LED lamp lights up for 0.5 seconds and then goes out, receiver module LED turns on, receiver module contact at off; when make the cap of emitter and receiver in alignment, receiver module LED is off, NC/NO is on ;when something or someone shelter the sensor, receiver module LED will turn on , NC/NO contact is off. When short circuit cap at NC, the state of NO/NO is opposite to the above phenomenon.
1*Transmitter1*Receiver1*Accessories
Certificate
모델 번호 : Single Infrared Beam Sensor
근원 : CN (정품)
Photocell wavelength: : 940nm
거리 : 15m
브랜드 이름 : Scimagic-RC
스마트 홈 플랫폼 : NONE
Receiver Working current: : Less than 30mA (24V DC)
Receiver Working voltage: : 12-24V DC
Transmitter Working voltage: : 2PCS AAA Battery NOT Include
증명서 : 세륨
Size: : 100*40*35mm
Relay contact loading capacity: : 1A/30VDC
ForA: : Infrared Beam Detector
Receiving range: : more than 12m
ForB: : Photocell infrared sensor detector
ForD: : Single Beam Sensor
ForC: : Garage Door Beams Detector